RESUMO
To verify the structural microdeformationby strain gages, around implants that have metal infrastructure, obtained by different materials and techniques impressions.Material and Methods:Three internal hexagon implants in polyurethane block (master model) with abutments were taken the impression with differents materials and techniques impression (n=4): addition silicon and transfer for open tray technique (Group I), condensation silicon and transfer for closed tray technique (Group II); and polyether and transfer for open tray techniques (GroupIII). Impressions were poured with type IV stone. Metallic infrastructure were made and installed in the master model by an aid of a manual ratchet wrench. A torque of 20N was used to install the metallic infrastructure. Microdeformation analysis was performed around the implants by strain gauge method. Two gauges were inserted into the polyurethane base, and three measurements were taken for each infrastructure. Data were analyzed using descriptive statistics and inference. Kruskal-Wallis test was used toverify association between materials and impression techniques and deformation around the implants, at 5% confidence.Results:Microdeformationsaround the implants showed no statistically significant difference (p = 0.123) between the experimental groups, Group I (215.8 με), Group II (194.9 με) and Group III (297.4 με). Conclusion:The use of different materials and techniques impression to madeof infrastructures for fixed implant-supported dental prosthesis did not present difference in microdeformation values around implants...
